How to Build a Worm Compost Bin
To build a worm compost bin, get a 10 to 20 gallon plastic storage tub with a lid, drill air holes near the top and drain holes in the bottom, and set it on bricks over a tray. Fill it with moist shredded newspaper bedding and a handful of soil or finished compost, then add red wigglers.
On this page (9 sections)
- What supplies do you need to build a worm compost bin?
- How do you drill and assemble the tub?
- What bedding should go into a new worm bin?
- How many worms does a worm compost bin need?
- Where should the bin live, and how do you keep it at the right temperature?
- How do you feed worms and keep the bin from smelling?
- How do you harvest castings and keep the bin going?
- Is a worm bin worth it compared with a compost tumbler?
- What should you do first when building your worm compost bin?
To build a worm compost bin, get a 10 to 20 gallon plastic storage tub with a lid, drill air holes near the top and drain holes in the bottom, and set it on bricks over a tray. Fill it with moist shredded newspaper bedding and a handful of soil or finished compost, then add red wigglers.
The build takes an afternoon and costs less than most garden projects. A working bin gives you a steady supply of castings from kitchen scraps you would otherwise throw away.
This guide covers the build, the bedding, the worms, the daily care and the harvest.
What supplies do you need to build a worm compost bin?
You need a plastic storage tub, a lid, a drill, bedding material and red wigglers. A tray to catch drips and a few bricks to lift the tub keep the floor clean.
Almost everything else comes from the recycling bin.
The tub is the only part worth buying new. A dark or opaque tub keeps light out, and a lid that snaps shut slows fruit flies.
A 10 gallon tub suits a small household; a 20 gallon tub handles more scraps.
For the drill, a 1/4 inch bit works for the air holes and a smaller 1/8 inch bit suits the drain holes. Shredded newspaper, plain cardboard or coco coir makes the bedding.
A handful of garden soil or finished compost adds the grit worms need to digest food.
Skip clear tubs if you can. Algae grows in light, and worms avoid the bright edges.
How do you drill and assemble the tub?
Drill a row of air holes about 2 inches below the lid line on each long side, and four to six drain holes in the bottom. Then set the tub on bricks inside a shallow tray.
Air moves through the top holes and any excess moisture drains into the tray instead of pooling in the bedding.
Keep the air holes small enough that worms cannot escape through them. Red wigglers rarely climb when conditions are right, but a 1/4 inch hole is wide enough for a small worm to squeeze through if the bedding gets too wet.
Place the bricks near the corners so the tub sits level. A plastic plant saucer or a second, shallow tub works as the drip tray.
Empty the tray whenever water collects; standing water under the bin invites smells and pests.
Don't drill holes in the lid itself. A solid lid keeps rain out and slows evaporation, while the side holes do the venting.
If the lid fits loosely, weigh it down with a brick.
When is a ready-made bin the better build?
Buy a ready-made bin when you want to skip the drilling and start feeding worms the same day. The Urban Worm Bag Version 2 arrives with an iron frame and assembles in less than 5 minutes without tools.
Its 900D oxford fabric is breathable, and the fully removable zipper-free bottom lets you collect castings without sorting worms out of trays. The bag holds up to 8 lb of worms and, at full capacity, can process 3 to 4 lb of household waste a day.
It takes up 26.75 x 26.75 inches of floor space. Starting from scratch, expect about 4 to 6 months before the first harvest.

A fabric bag with an open bottom for harvesting castings without sorting worms by hand.
See it on AmazonWhat bedding should go into a new worm bin?
Shredded newspaper or plain cardboard soaked until damp, then wrung out, is the standard bedding. It holds moisture, gives the worms somewhere to hide and adds the carbon that balances wet food scraps.
Aim for bedding that feels like a wrung-out sponge. Squeeze a handful: a few drops should fall, not a stream.
Dry bedding dries out worms, and soggy bedding smothers them.
Fill the tub about two-thirds full and fluff the bedding so it stays loose. Packed bedding goes anaerobic and smells.
Add a couple of handfuls of soil or finished compost and mix it through; this seeds the bin with the microbes that break scraps down.
Avoid glossy paper, heavily inked paper and anything with plastic tape. Tear or shred bedding into strips about an inch wide.
How many worms does a worm compost bin need?
Start with about 1 lb of red wigglers for a 10 gallon tub. Red wigglers are the right species for bin composting: they stay near the surface, tolerate crowding and eat scraps faster than garden earthworms.
Uncle Jim's Worm Farm sells red wigglers in a 1000 count mix. The worms come from beds the farm has kept for decades, so the mix may include more than one earthworm species; Uncle Jim's says that diversity lets the worms work all layers of the compost.
The company has raised worms in the US for over 50 years. Add the worms on top of the bedding and leave the lid off for an hour or so; they will work their way down on their own.
Don't add worms and food on the same day. Let them settle into the bedding first.
Check after a week: if the worms are spread through the bedding and active, the bin is ready for its first scraps.

A 1000 count mix of red wigglers to seed a new bin.
See it on AmazonWhere should the bin live, and how do you keep it at the right temperature?
Keep the bin in a cool, dark spot between about 55 and 77°F. A basement, garage or shaded porch works.
Heat above that range stresses worms, and freezing temperatures stop them feeding.
Check the spot before you commit. Direct afternoon sun on a plastic tub can push the inside well past the air temperature.
A spot that stays damp and out of the wind is better than a sunny corner.
An outdoor bin needs more planning. Our guide to whether a worm bin can stay outside in winter covers insulation and moving the bin indoors.
A garage bin that never freezes is the simplest option in cold climates.
Keep the lid on and the bin level. If the spot is drafty, stack straw bales or old blankets around the tub in cold months.
How do you feed worms and keep the bin from smelling?
Feed worms buried kitchen scraps in small amounts, and keep the bedding as damp as a wrung-out sponge. Bury each addition under fresh bedding so flies cannot reach it.
Rotate the feeding spot around the tub.
Red wigglers eat vegetable and fruit scraps, coffee grounds, tea leaves and crushed eggshells. Skip meat, dairy, oily food and pet waste, which smell and attract pests.
Chop large pieces so they break down faster.
Feed about 3 to 4 lb of scraps a week per pound of worms once the colony is established, and less while it settles. If food sits uneaten for a week, feed less.
If the bin smells sour, add dry bedding and stop feeding for a few days.
Fruit flies are the usual complaint. Bury food deeper and keep the lid closed.
A jute mat laid on the bedding keeps the surface dark and moist and makes it harder for flies to reach food scraps. The Urban Worm Blanket measures 24 x 24 inches and fits larger bins; you can cut it to size for smaller tubs.

A jute mat that covers the bedding, keeps it dark and damp and slows fruit flies.
See it on AmazonHow do you harvest castings and keep the bin going?
Let the bin run for 3 to 4 months, then move the finished castings to one side and feed only the other side. The worms migrate toward the fresh food.
After a few weeks, scoop out the worm-free side.
Our step-by-step guide to how to harvest worm castings covers the migration method and the dump-and-sort method in detail.
Harvest when the bedding has turned dark and crumbly and few recognizable scraps remain. Don't wait until the bin is full of castings; crowded bins get wet and the worms slow down.
After harvesting, refill the empty side with fresh bedding and start feeding there. Save a few handfuls of finished castings to seed the next batch.
This rotation keeps the colony productive for years.
If the bin is new and you are still learning the routine, read how to start a worm bin step by step before your first harvest. It covers the settling-in period and the mistakes that slow a colony down.
Is a worm bin worth it compared with a compost tumbler?
A worm bin wins for small spaces and fast castings; a compost tumbler wins for larger volumes of yard waste. Worms process kitchen scraps indoors or on a porch and give you a rich amendment in months.
A tumbler handles leaves, grass and garden trimmings in bigger batches.
A worm bin takes up little floor space and needs no turning. A tumbler needs regular spins and more room.
Our comparison of a worm bin vs a compost tumbler helps you match the choice to your yard and the waste you produce. Many gardeners run both.
What should you do first when building your worm compost bin?
Build the tub bin first if you have kitchen scraps and a cool, dark spot; buy a ready-made bag if you would rather not drill. Either way, the bedding and the worms matter more than the container.
Get those right and the bin will run with little attention.
To build a worm compost bin cheaply, start with a 10 gallon tub, drill the holes, and buy 1 lb of red wigglers. If drilling sounds like a chore, the Urban Worm Bag Version 2 skips the build and makes harvesting easier.
Once the bin is running, keep feeding and turn the castings over every few months. A well-run tub keeps producing compost for years with only scraps and a little bedding as inputs.
Frequently asked questions
How much does it cost to build a worm compost bin?
A homemade bin is one of the cheapest routes into vermicomposting. The main costs are a storage tub, a lid and a pack of red wigglers; drilling tools and a drip tray often come from what you already own.
A ready-made fabric bag costs more but saves the drilling and the guesswork.
What size tub do I need for a worm compost bin?
Pick a tub of about 10 to 20 gallons for a two-person household. The footprint should give each worm enough surface area, and depth matters more than volume: worms work the top few inches of bedding, so a shallow, wide tub beats a deep, narrow one.
Where should I keep a worm compost bin?
Keep it in a cool, dark spot between about 55 and 77°F. A garage, basement, utility room or shaded porch works well.
Avoid direct sun, which cooks the bin, and freezing spots, which slow the worms down.
An outdoor bin needs extra cover in cold months.
How long until a worm compost bin makes castings?
Expect usable castings in about 3 to 4 months from a new setup. The worms need time to settle and multiply, and food breaks down faster in warm, moist bedding.
You can speed things up by starting with a few handfuls of finished compost in the bedding.
About this guide: Our look at building a worm compost bin draws on maker specs, materials and what owners report. See how we research.



